2)
Open the loading gate and rotate the
cylinder to ensure the pistol is unloaded.
3)
Turn the ejector rod counter clockwise 1/2
turn.
4)
Pull the ejector rod forward.
5)
Rotate the ejector sleeve clockwise if
holding the pistol as shown in figure 5.
6)
On the left hand side of the pistol you will
see two small marks that are cut into the
ejector sleeve and the frame. Line up
the two lines as shown in figure 6.
7)
Now pull the cylinder pin forward.
8)
Remove the cylinder pin and set aside.
9)
Remove the cylinder from as shown in figure
9.
Reassembly
Instructions
10)
Open the loading gate of the pistol.
11) Insert the cylinder.
12) Line up the cylinder pin as shown in
figure 12.
13) Slide the cylinder pin into place.
14) Rotate the ejector sleeve counter
clockwise if holding the pistol as shown in
figure 14.
