1) Make sure the carbine is pointed in a
safe direction and pull the operating slide back to make
sure the carbine is unloaded.
Note: Operating slide lock
is small button at top of operating slide near the handle (as shown
in figure 1).
2) Depress the operating slide lock
while holding the slide back and the operating slide will
lock into place.
3) Depress the magazine release.
4) Remove the magazine.
5) Once you are sure the carbine is unloaded
and safe, pull the operating slide handle to the rear and
let go and it will close.
6) Loosen the screw on the barrel band.
7) Depress the band spring.
8) Slide the barrel band off of the
stock.
9) Remove handguard and set it aside.
10) Pivot the barrel as show in
figure 10.
11) Remove the barrel and receiver
from stock.
12) Remove the trigger guard pin
and set it aside.
13) The trigger assembly is attached
via guides at the front and rear of the bottom of the receiver.
14) Slide the trigger assembly forward
and remove it from the receiver.
15) As shown in figure 15, the
recoil spring guide fits into a guide hole in the operating
slide.
16) Remove the recoil spring guide
by compressing it as shown in figure 16.
17) Pivot the recoil spring guide
to the side and remove from receiver. Separate
recoil spring from recoil spring guide.
18) Pivot the bolt and remove as
shown in figure 18.
19) Slide the operating slide forward
and lift up at indent in side of receiver.
20) Figure 20 shows that the operating
slide and how it aligns with the receiver. Note
the notch in the receiver where you can slide the operating
slide from the guide rails.
21) Figure 21 shows the correct way
of removing the operating slide from the receiver.
22) Figure 22 shows the disassembled carbine.
Reassembly Instructions
23) Return bolt to receiver.
24) Position arm of bolt as shown
in figure 24.
25) Insert front of operating slide
as shown in figure 25 and guide it onto the receiver's
guide rails.
26) Connect operating slide to
bolt as shown in figure 26.
27) Carefully cycle operating slide
and bolt to ensure no binding.
28) Place recoil spring over recoil
spring guide.
29) Feed recoil spring guide into
receiver.
30) Place end of recoil spring guide
into the guide hole as shown in figure 30.
31) Carefully cycle operating slide
and bolt to ensure no binding.
32) Align trigger assembly to guides
on receiver.
33) Slide trigger assembly to the
rear.
34) Replace the trigger guard pin.
35) Figure 35 shows how the receiver
is placed under the recoil plate (the recoil plate
is a the small piece of metal that is screwed into the rear of the
stock's receiver area as shown in figure 35). Pivot
receiver and barrel into place in the stock.
36) Install hand guard.
37) Slide barrel band to the rear and lock
into place via the band spring.
38) Tighten the barrel band screw.
39) For the last time - Carefully cycle
operating slide and bolt to ensure no binding.
40) Figure 40 shows the completed
reassembly of the carbine.
