|
Photos and Instructions
by Eric (dieschem) |
|
|
|
 |
1)
Figure 1 is an assembled CETME. |
 |
2)
Visually and manually ensure that the rifle
is unloaded, and remove the magazine. Once
you are sure the rifle is unloaded, cock the
rifle, let the charging handle return to the
front and leave it cocked. Remove the 2
retaining pins at the stock end of the
receiver by pushing on the pins, and then
pulling them out. If needed, use the flat of
a screwdriver to gently lift the pins after
you've started them. (one pin is always
harder to remove for some reason, usually
the back one) |
 |
3)
Remove the stock by placing your weak hand
on the back of the pistol grip and your
strong hand around the stock, and pull. It
is usually pretty hard to get off the first
few times so you might need to give the
sides of the end of the stock a few raps
with the flat of your hand to loosen it up. |
 |
4)
Remove the trigger pack and pistol grip
assembly by pulling the grip down and away
from the reciever. Leave the hammer cocked.
If the hammer isn't cocked, you wont be able
to reinstall the bolt body into the
reciever.
|
 |
5)
Place your right hand under the opening at
the rear of the reciever, and with the rifle
pointed slightly barrel up, slowly pull the
charging handle to the rear. |
 |
6)
The bolt body will slide out into your right
hand. The bolt body is fairly heavy so be
careful when you pull the charging handle
back, or the bolt body will smack your hand
as it comes out!
|
 |
7)
Shows the location of the fore end retaining
screw at the muzzle end of the fore end. |
 |
8)
Depress the fore end retaining pin and
remove. |
 |
9)
Remove the fore end by rotating it down and
away from the muzzle end of the rifle.
|
 |
10)
Disassembled components, top to bottom and
left to right. -Stock -Stock Retaining Pins
-Reciever/Barrel Assembly -Bolt Body -Fore
End -Fore End Retaining Pins -Trigger Pack |
| |
